Archive for June, 2007

Improving Symmetry »

By on 2007-06-09 in Models | 0 Comments
Tags: ,

After earlier work I decided that the snout of the head part looked crooked. To solve the problem I split the head in half down the middle, to make it easier to take measurements relative to the center line. This was relatively easy because the part was built with a thin styrene plate on the […]

Fourth and Fifth Attempts »

By on 2007-06-09 in Models | 0 Comments
Tags: ,

The third version of the chest block part had a few problems: in particular it was prone to warping and it didn’t have the holes on the bottom of the chest block drilled out, or even marked. As a result I decided to remake the chest block part from thicker stock, and drill out the […]